LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2436 (Engine - 6.4L 99R Diesel -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean the crankshaft front seal mounting surface.
  2. Apply threadlock to the outer circumference of the leading edge of the crankshaft.
    3. NOTE: New seal and wear sleeve must not be separated.
  3. Using the Crankshaft Seal Installer, install a new oil seal and wear sleeve assembly.
    4. Fig 1: Installing New Oil Seal & Wear Sleeve Assembly Using Crankshaft Seal Installer
    GF0048507Courtesy of FORD MOTOR CO.
  4. Install the crankshaft pulley. For additional information, refer to Crankshaft Pulley .
scientia non olet · About LEMON Manuals