Core Plug Replacement
WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Material
| Item | Specification |
|---|---|
| Threadlock 262 TA-26 |
WSK-M2G351-A6 |
- To remove the cylinder block core plug, use a punch and hammer near the edge of the plug and strike with a hammer.
- Clean the crankcase opening.
- Coat the edges of the new cylinder block core plug and crankcase with threadlock prior to installing the cup plug.
- Using an appropriate tool, install the new cylinder block core plug. It should be flush with the crankcase surface to approximately 1.50 mm (0.05 in) below the surface.
- Clean off the excess threadlock.