Connecting Rod Bushing Diameter
WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Using a suitable solvent, thoroughly clean the connecting rod and cap.
- Mark each connecting rod and its corresponding cap.
- Use a telescoping gauge and a 25-50 mm (1-2 in) micrometer to measure the inside diameter of the piston pin bushing. Install a new connecting rod if not within specifications. For additional information, refer to SPECIFICATIONS .
- Measure the piston pin diameter in 2 directions at the points shown. Verify the diameter is within specification. For additional information, refer to SPECIFICATIONS .
- If out of specification, install a new piston pin.
Fig 1: Using Telescoping Gauge & 25-50 mm (1-2 in) Micrometer To Measure Inside Diameter Of Piston Pin Bushing