LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2436 (Engine - 6.4L 99R Diesel -- F250-F550 Super Duty) >> General Procedures >> Camshaft Journal to Bearing Clearance

Camshaft Journal to Bearing Clearance

WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the 5 camshaft bushings for wear and correct running clearance.
  2. Use a telescoping gauge and a 50-75 mm (2-3 in) micrometer to measure the camshaft bushing inside diameter with the bushings installed in the crankcase.
    3. Fig 1: Using Telescoping Gauge And 50-75 Mm Or 2-3 Inch Micrometer To Measure Camshaft Bushing Inside Diameter
    GF0034883Courtesy of FORD MOTOR CO.
  3. To determine running clearance, subtract previous camshaft journal diameter readings from camshaft bushing inside diameter readings.
  4. If maximum allowable running clearance is exceeded, install new camshaft bushings. For additional information, refer to SPECIFICATIONS .
scientia non olet · About LEMON Manuals