LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2428 (Engine Ignition System - 5.4L And 6.8L (3V) -- F250-F550 Super Duty) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ignition coil-on-plug electrical connector.
  2. Remove the bolt and the ignition coil-on-plug.
    • Remove the ignition coil-on-plug, using a twisting motion while pulling up on the ignition coil-on-plug.
    • To install, tighten to 6 Nm (53 lb-in).
    3. NOTE: Verify that the ignition coil-on-plug spring is correctly located inside the ignition coil-on-plug boot and that there is no damage to the tip of the boot.
  3. To install, reverse the removal procedure.
    • Apply a light coat of dielectric compound to the inside of the ignition coil boots.
scientia non olet · About LEMON Manuals