Removal And Installation

WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

If equipped, remove the overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
Remove the RH and LH sun visor screws and the sun visors.
- If equipped, disconnect the electrical connectors.

Fig 1: Locating Left And Right Visors

Courtesy of FORD MOTOR CO.

Remove the RH and LH sun visor retaining clips.
- Remove the sun visor retaining screws.

Fig 2: Locating Left And Right Visor Arm Clips

Courtesy of FORD MOTOR CO.

Remove the RH and LH A-pillar trim panels. For additional information, refer to A-Pillar Trim Panel .
Remove the RH and LH B-pillar trim panels. For additional information, refer to B-Pillar Trim Panel - SuperCab .
Remove the RH and LH rear garment hooks.
- Open the rear garment hook screw access covers.
- Remove the 2 rear garment hook screws.
Lower the glove compartment.
1. Open the glove compartment.
2. Depress the glove compartment stop and lower the glove compartment.

Fig 3: Identifying Lower Glove Compartment

Courtesy of FORD MOTOR CO.

Through the glove compartment opening, disconnect the headliner electrical connector that is located at the RH instrument panel, toward the front of the vehicle.
Remove the RH and LH rear door latch covers.

Fig 4: Identifying Rear Door Latch Covers

Courtesy of FORD MOTOR CO.

Remove the 3 headliner push pin retainers.

CAUTION: Make sure not to crease the headliner when removing it from the vehicle.

With the help of an assistant, remove the headliner.
To install, reverse the removal procedure.