Recommended Procedure
WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Connect the scan tool. Turn off all accessories. If the vehicle is equipped with a PTO system or auxiliary idle control, it must be turned off to carry out the self-test.
- Carry out the necessary vehicle preparation and a visual inspection. Refer toQUICK TEST OPERATION .
- Refer to the scan tool operating article for instructions.
- Key ON, engine OFF.
- Follow the operating instructions from the diagnostic menu.
- Record the continuous DTCs and freeze frame information and carry out the appropriate pinpoint test for continuous DTC diagnostics.
- Clear the continuous DTCs after a repair.