Ignition Switch: Installation

Ensure ignition lock is in RUN position. Slot in actuator housing should be aligned with mark on steering column casting. Align pin on ignition switch with slot in actuator housing. Connect ignition switch electrical connector, and tighten retaining screws to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.

Turn ignition lock cylinder to LOCK position. Place actuator rod on switch. Place switch on column studs while aligning rod hole in ignition switch with actuator rod. Tighten retaining nuts to specification. See TORQUE SPECIFICATIONS . Check switch for proper operation in all positions. To complete installation, reverse removal procedure.