LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Windstar Base >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panels - Analog >> Self-Diagnostic System >> Instrument Cluster Dealer Test Mode Displays

Instrument Cluster Dealer Test Mode Displays

  1. All Segments Illuminated

    Illuminates all odometer segments.

  2. "GAGE"

    Activates gauge sweep of all gauges, then displays present gauge values. Also carries out checksum tests on ROM and EE.

  3. "bulb"

    Illuminates all micro-controlled lamps and LEDs.

  4. "r"

    Returns to normal operation of all micro-controlled lamps and LEDs. Displays hexadecimal value of ROM level.

  5. "EE"

    Displays hexadecimal value of for EE level.

  6. "dt"

    Displays hexadecimal coding of final manufacturing test date.

  7. "dtc"

    Displays DTCs. Pressing trip odometer/reset button will display any DTCs stored before proceeding to next step.

  8. "cFG0"

    Displays coding of software configurable features/options.

  9. "cFG1"

    Displays coding of software configurable features/options.

  10. "cFG2"

    Displays coding of software configurable features/options.

  11. "cFG3"

    Displays coding of software configurable features/options.

  12. "SPd xxx.x mi"

    Displays English speed in MPH. Speedometer will indicate present speed within tolerance. Display will show zero if input is not received. If input received is invalid for one second or more, or if speed is zero.

  13. "SPd xxx.x kmi"

    Displays English speed data from PCM via SCP network. Displays metric speed in KPH. Speedometer will indicate present speed within tolerance. Display will show zero if input is not received. If input received is invalid for one second or more, or if speed is zero.

  14. "tAc xxxx"

    Displays tachometer data being received from PCM via SCP network. Tachometer will indicate present RPM within tolerance. Display will show zero if input is not received. If input received is invalid for one second or more, or if engine RPM is zero.

  15. "FuEL"

    Displays actual A/D fuel level. Fuel gauge will display a filtered fuel level value. This filter will keep pointer from moving suddenly or erratically. If value displayed is between zero and 20, circuit is shorted. See FUEL LEVEL VALUE  table.
    FUEL LEVEL VALUE

    Gauge Reading Value
    Open Sending Unit 255
    Full Stop 222-242
    Full Mark 205-225
    3/4 Mark 170-186
    1/2 mark 131-145
    1/4 Mark 88-98
    Empty Mark 37-45
    Low Fuel Indicator 21-59
    Short Circuit 0-20

  16. "dEGC"

    Display of engine temperature in Celsius. Input from cylinder head temperature sensor. If value displayed is -40 C°, SCP message for engine temperature has not been received for more than 5 seconds. See TEMPERATURE VALUE  table.
    TEMPERATURE VALUE

    Temperature Displayed Value
    Cold Mark 49C
    Normal Band Start 60C
    Normal Band End 120C
    No Message for 5 seconds -40C
scientia non olet · About LEMON Manuals