LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Steering >> Manual Steering >> Power Rack & Pinion >> Removal & Installation >> CIII - Pump Pulley >> Removal

CIII - Pump Pulley: Removal

  1. Remove the accessory drive belt. See SPECIFICATIONS & DRIVE BELT ROUTING -- CARS - 1999 or SPECIFICATIONS & DRIVE BELT ROUTING -- CARS - 2000-2001 under ENGINE.
  2. Raise and support vehicle.
  3. Using Pump Pulley Remover (211-016), remove pulley. Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, discard and install a new pulley. If there is no paint or one paint mark, use a paint pencil to mark the web area of the pulley near the hub. See Figure .
scientia non olet · About LEMON Manuals