LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 3.8L V6 (VIN 4) >> Removal & Installation >> Cylinder Head >> Inspection

Cylinder Head: Inspection

CAUTION: DO NOT machine more than .010" (.25 mm) from original cylinder head thickness or cylinder block surface.
  1. Inspect cylinder head for cracks or warpage. Machine cylinder head if warpage exceeds specification. See CYLINDER HEAD  table under ENGINE SPECIFICATIONS.
  2. Check cylinder block deck surface. Machine cylinder block if warpage exceeds specification. See CYLINDER BLOCK  table under ENGINE SPECIFICATIONS.
scientia non olet · About LEMON Manuals