LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 3.8L V6 (VIN 4) >> Removal & Installation >> Crankshaft Front Oil Seal >> Removal

Crankshaft Front Oil Seal: Removal

  1. Disconnect electric cooling fan motor connector. Remove fan shroud and electric cooling fan motor assembly. Remove accessory drive belt(s). Place reference mark on crankshaft pulley and vibration damper for reassembly reference. Remove crankshaft pulley.
  2. Remove vibration damper retaining bolt. Using Vibration Damper Remover (T58P-6316-D) and Adapter (T82L-6316-B), remove vibration damper. Using screwdriver, pry seal from front cover.
scientia non olet · About LEMON Manuals