Possible Causes

Driver-side air bag circuit low resistance could be caused by short in clockspring windings, short in wiring harness, low resistance in driver-side air bag module, or damaged or inoperative RCM.

1. Check driver-side air bag module
   
   Turn ignition switch to OFF position. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Turn ignition switch to RUN position. Perform on-demand self-test. See ON-DEMAND SELF-TEST  under DIAGNOSTICS. If DTC B1934 is retrieved, go to next step. If DTC B1934 is not retrieved, replace driver-side air bag module. Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Clear DTCs. See CLEARING FAULT CODES  under DIAGNOSTICS. Repeat on-demand self-test.
2. Check driver-side air bag module circuit
   
   Turn ignition switch to OFF position. Access RCM and disconnect harness connector C424. See RESTRAINTS CONTROL MODULE (RCM)  under REMOVAL & INSTALLATION. Disconnect driver-side air bag module simulator. Measure resistance between RCM harness connector C424, terminals No. 2 (Green-Red wire) and No. 3 (Black-Orange wire). See Figure. If resistance is more than 10 k-ohms, replace RCM. Activate air bag system. Clear DTCs. Repeat on-demand self-test. If resistance is less than 10 k-ohms, go to next step.
3. Check driver-side air bag module wiring
   
   Disconnect lower clockspring connector. Measure resistance between RCM harness connector C424, terminals No. 2 (Green-Red wire) and No. 3 (Black-Orange wire). If resistance is more than 10 k-ohms, replace clockspring. See CLOCKSPRING  under REMOVAL & INSTALLATION. Activate air bag system. Clear DTCs. Repeat on-demand self-test. If resistance is less than 10 k-ohms, repair short between Green-Red and Black-Orange wires. See WIRING DIAGRAMS . Activate air bag system. Clear DTCs. Repeat on-demand self-test.