Test F: Passenger's Power Window Inoperative (2 & 4-Door)
- Turn ignition switch to LOCK position. Disconnect passenger's power window control switch harness connector C489. Test passenger's power window control switch. See PASSENGER'S POWER WINDOW CONTROL SWITCH under COMPONENT TESTS. If passenger's power window control switch is okay, go to next step. If passenger's power window control switch is faulty, replace passenger's power window control switch. Retest system operation.
- Connect passenger's power window control switch harness connector C489. Disconnect passenger's power window motor harness connector C783. Turn ignition switch to RUN position. Measure voltage between ground and passenger's power window motor harness connector C783 terminal No. 2 (White/Violet wire) while pressing passenger's power window control switch to down position. If battery voltage exists, go to next step. If battery voltage does not exist, repair open or short to ground in White/Violet wire between passenger's power window motor and passenger's power window control switch.
- Measure voltage between ground and passenger's power window motor harness connector C783 terminal No. 1 (Yellow/Violet wire) while pressing passenger's power window control switch to up position. If battery voltage exists, replace passenger's power window motor and retest system operation. If battery voltage does not exist, repair open or short to ground in Yellow/Violet wire between passenger's power window motor and passenger's power window control switch.