Gear Mode (Drive Mode)
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2003 Mazda B4000, 2003 Mazda B3000, 2003 Mazda B2300, 2002 Mazda B4000, and 2002 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
Gear mode is used to test transmission shift functions. The OSC COMMAND VALUES allow for the following options:
- (1)
PCM selects 1st gear. - (2)
PCM selects 2nd gear. - (3)
PCM selects 3rd gear. - (4)
PCM selects 4th gear. - (5)
PCM selects 5th gear.
Perform the following procedure for GEAR MODE:
- Select OUTPUT STATE CONTROL.
- Select TRANS-DRIVE MODE.
- Select PIDs to be monitored.
- Monitor all selected PIDs during test.
- Select "Parameters - GEAR".
- Select OSC COMMAND VALUE 1-5, then press SEND.
- Re-select OSC value 1-5, then press SEND.
- Select "XXX", then press SEND at any time to cancel any command sent.