LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Focus LX, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2177 (Automatic Transmission - 5R110W -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Transmission Support CROSSMEMBER >> Removal

Transmission Support CROSSMEMBER: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Install a suitable high-lift transmission jack.
  3. Remove the wire harness from the rear crossmember.
    4. Fig 1: Locating Wire Harness At Rear Of Crossmember
    G03908863Courtesy of FORD MOTOR CO.
  4. Remove the rear transmission insulator nuts.
    5. Fig 2: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
  5. Remove the LH crossmember bolts and nuts.
    • Loosen, but do not remove, the bolt and nut indicated.
    6. Fig 3: Locating LH Crossmember Bolts
    GF0006799Courtesy of FORD MOTOR CO.
  6. Remove the RH crossmember bracket bolts and nuts.
    • Remove the bracket bolts and nuts.
    • Remove the bracket.
    7. Fig 4: Locating RH Crossmember Bracket Bolts
    GF0006800Courtesy of FORD MOTOR CO.
  7. Remove the RH crossmember bolts and nuts.
    8. Fig 5: Identifying RH Crossmember Bolts And Nuts
    G03920816Courtesy of FORD MOTOR CO.
  8. Remove the LH crossmember bolt, nut and the crossmember.
    • Remove the bolt and nut
    • Remove the crossmember.
    9. Fig 6: Locating LH Crossmember Bolt
    GF0006801Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals