Transmission Support CROSSMEMBER: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Crossmember To Transmission Mount Nut

Courtesy of FORD MOTOR CO.

Position the crossmember to the transmission insulator and loosely install the nut.
Install the LH crossmember bolts.
- Tighten to 81 Nm (60 lb-ft).

Fig 2: Locating LH Crossmember Bolts

Courtesy of FORD MOTOR CO.

Install the RH crossmember bolts.
- Tighten to 81 Nm (60 lb-ft).

Fig 3: Identifying RH Crossmember Bolts And Nuts

Courtesy of FORD MOTOR CO.

Install the bracket and loosely install the bolts.
- Install the bracket.
- Loosely install the bolts.

Fig 4: Identifying Bracket And Bolts

Courtesy of FORD MOTOR CO.

Tighten the RH crossmember bolts.
- Tighten to 81 Nm (60 lb-ft).

Fig 5: Locating RH Crossmember Bolts

Courtesy of FORD MOTOR CO.

Tighten the rear insulator nuts.
- Tighten to 103 Nm (76 lb-ft).

Fig 6: Identifying Transmission Support Insulator Nuts

Courtesy of FORD MOTOR CO.

Connect the wire harness to the rear of the crossmember.

Fig 7: Locating Wire Harness At Rear Of Crossmember

Courtesy of FORD MOTOR CO.