Removal & Installation
- Disconnect battery ground cable. Disconnect electrical connector from filler cap. Remove fluid reservoir filler cap. Raise and support vehicle. Remove front wheels.
- Remove dust cap and loosen bleed nipple. Connect a bleed tube to bleed nipple and into a suitable container. Pump brake pedal until all fluid is expelled. Tighten bleed nipple. Lower vehicle. Install brake fluid reservoir cap. Remove air cleaner and air cleaner outlet tube.
- Disconnect central electrical box electrical connector. Remove central electrical box retaining screw. Remove central electrical box and relocate to air cleaner area. Disconnect brake fluid feed tube. Disconnect brake lines.
- On models with anti-lock brakes, disconnect brake lines from Hydraulic Control Unit. On all models, remove brake booster vacuum hose. Extract master cylinder from vehicle.
- On models with manual transaxles, remove clutch hose from brake/clutch reservoir. On all models, remove master cylinder nuts and remove master cylinder. To install, reverse removal procedure. Bleed brake system. See BLEEDING BRAKE SYSTEM .