LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Focus LX, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 3001 (Engine Controls - Pinpoint Test KP: Charge Air Cooler (CAC) Pump Through Pinpoint Test Z: Intermittent - (Except Diesel & Hybrid)) >> PINPOINT TEST Z: Intermittent >> Introduction

PINPOINT TEST Z: Intermittent: Introduction

WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Crown Victoria Police Interceptor vehicles equipped with fire suppression system, refer to FIRE SUPPRESSION SYSTEM article for Important Safety Warnings. Failure to follow these instructions may result in personal injury.

This pinpoint test is intended to diagnose and isolate intermittent concerns for the following:

This chart is used to determine which test to run for the suspect circuit. PIDs corresponding to each circuit are listed. Some circuits do not have an associated PID or the PID may not be available and has to be measured with a digital multimeter (DMM). More specific information on the PID can be found. If the vehicle has a coil pack system with a no start condition, carry out the ignition test.

PCM PIDS/SIGNALS

PCM/TCM PIDS/SIGNALS Associated Circuit Test Type
4X4 4X4 input
ACCS A/CCS input
ACET ACET input
ACP ACPSW input
AIR AIR output
AIRM AIRM input
APP1 APPS input
APP2 APPS input
APP3 APPS input
BOO BPS input
CCS CCS output
Use DMM CD A-J (primary) output
CHT CHT input
CKP CKP input
CMP CMP input
CPP/PNP CPP input
CTO CTO output
DPFEGR DPFE input
ECT ECT input
EGRMC1 EGRMC1 output
EGRMC2 EGRMC2 output
EGRMC3 EGRMC3 output
EGRMC4 EGRMC4 output
EGRMDSD EGRMC output
EVR EVR output
EOT EOT input
EPC, EPCV EPC output
EVAPCV CV output
EVAPPDC VMV output
EVAPPF VMV output
FANDC VDF output
FANSS FANSS input
FLI FLI input
FP FP output
FPM FPM input
FP M FPM input
FRP FRP input
FRT FRT input
FTP FTP input
GENCM/ILINE GENRC output
GENMN GFS GENLI input
HFC HFC output
HOS11 HEGO input
HOS12 HEGO input
HOS13 HEGO input
IAC IAC output
IAT IAT input
IAT2 IAT 2 input
IMRC IMRC output
IMRC1M IMRCM input
IMTV1 IMTV1 output
IMTV2 IMTV2 output
ISS_SRC ISS input
KS1 KS1 input
KS2 KS2 input
LFC LFC output
MAF, MAF V MAF input
MAP V MAP input
O2S11 O2S input
O2S12 O2S input
O2S13 O2S input
OSS OSS input
PSP PSP input
PSPT PSP input
PTO PTO input
SSA/SS1 SS1 output
SSB/SS2 SS2 output
SSC/SS3 SS3 output
SSD/SS4 SS4 output
TACM (+) TACM (+) output
TACM (-) TACM (-) output
TP1 TP1 input
TP2 TP2 input
TCC TCC output
TCIL TCIL output
TCS TCS input
TFT TFT input
TP TP input
TSS TSS input
VCT1 VCT1 output
VCT2 VCT2 output
VPWR VPWR input
Use DMM VREF output
Use DMM VSO output
VSS VSS+ input
WAC WAC output