LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Explorer Chassis >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panels - Analog >> Component Tests >> Oil Pressure Gauge

Oil Pressure Gauge

  1. Turn ignition switch to LOCK position. Disconnect oil pressure switch connector. Connect Instrument Gauge System Tester (014-R1063) to oil pressure switch connector Dark Green/White wire. Set tester to infinite resistance. Turn ignition switch to RUN position, wait 60 seconds and read gauge.
  2. Center line on oil pressure gauge needle should fall on or below the "L" mark. Connect oil pressure switch connector Dark Green/White wire to ground. Center line on oil pressure gauge needle should fall slightly above mid-scale. If oil pressure gauge does not function as specified, replace gauge. If oil pressure gauge functions as specified, replace oil pressure switch.
scientia non olet · About LEMON Manuals