Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Drain the engine cooling system. For additional information, refer to ENGINE COOLING article.
Remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
Disconnect the engine vent and radiator vent hoses.

Fig 1: Locating Engine Vent And Radiator Vent Hoses

Courtesy of FORD MOTOR CO.

Remove the 2 bolts and position the degas bottle aside.
- To install, tighten to 10 Nm (89 lb-in).

Fig 2: Locating Degas Bottle Bolts

Courtesy of FORD MOTOR CO.

Loosen the clamp at the turbocharger. Disconnect the vent tube and remove the turbocharger intake tube.

Fig 3: Locating Vent Tube And Remove The Turbocharger Intake Tube

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.