Removal & Installation
- Disconnect negative battery cable. Remove air cleaner assembly. On Escape 3.0L, disconnect EVAP emission canister purge valve, and position aside. On all models, disconnect the master cylinder by removing the nuts and position aside. Disconnect speed control and accelerator cables if necessary. Remove speed control module bolts and position speed control aside. Remove vacuum hose from booster check valve.
- Remove instrument panel lower cover. Remove cotter pin holding stoplight switch to brake pedal arm. See Fig 1. Remove bushing and spacers. Remove booster mount nuts, and then remove booster. To install, reverse removal procedure.
Courtesy of FORD MOTOR CO.