SS1, SS2, SS3, SS4 & TCC Solenoids (Bench Mode)
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2003 Mazda B4000, 2003 Mazda B3000, 2003 Mazda B2300, 2002 Mazda B4000, and 2002 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
This procedure ensures TCC and shift solenoids may be turned on or off. Ensure parking brake is set, gearshift lever is in "P" position, and ignition switch is in ON position (engine off). Follow the procedure in order to test appropriate solenoid.
- Select OUTPUT STATE CONTROL.
- Select TRANS-BENCH MODE.
- Select PIDs to be monitored (SS1, SS2, SS3, SS4 or TCC).
- Monitor all selected PIDs during test.
- Select Parameters - SS1, SS2, SS3, SS4 or TCC.
- Select ON, then press SEND to turn solenoid on.
- Select OFF, then press SEND to turn solenoid off.
- Select "XXX", then press SEND at any time to cancel any command sent.