Removal & Installation (Rear)
- Remove rear seat cushion. Fold down second row seat back rest. Remove rear seat bolster bolt. Move right lower "B" pillar out of the way. Using Safety Belt Bolt Bit (501-010), remove auxiliary seat safety belt D-ring cover and bolt. Move quarter trim panel out of way. Using safety belt bolt bit, remove second row safety belt anchor bolt. Remove retaining clip from second row safety belt D-ring bolt. Using safety belt bolt bit, remove auxiliary seat safety belt retractor bolt and feed safety belt through quarter trim panel. Remove right quarter trim panel.
- Remove both filler and vent hoses from rear window washer reservoir. Depress 2 locking tangs on rear washer filler spout. Pull rear washer fill spout and hose out of body and remove them from vehicle. Disconnect electrical harness connector from rear washer pump.
- Remove washer hose from rear washer pump. Remove 2 bolts and nut retaining washer reservoir and remove it from vehicle. Pull rear washer pump straight out of reservoir. Remove one-piece seal from rear washer pump and inspect for damage.
- To install, reverse removal procedure. Use soap solution to coat rear washer pump seal prior to installation. Tighten rear seat bolster bolt 17 ft. lbs. (23 N.m). Tighten safety belt anchor bolts 30 ft. lbs. (40 N.m).