LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission Removal & Installation >> Removal & Installation >> Cd4E >> Installation (Contour, Cougar & Mystique)

Installation (Contour, Cougar & Mystique)

  1. To install, reverse removal procedure. Ensure torque converter is fully seated before proceeding. Torque converter centering spigot must be.470" (12 mm) below surface of bellhousing.
  2. Install NEW circlip on CV joint stub shaft. Carefully align splines on axle shaft with differential splines. Push CV joint until circlip seats in groove in side gear.
  3. Prior to subframe installation, install Subframe Alignment Pin Set (T94P-2100-AH). Tighten subframe-to-body bolts to specification and remove alignment pin set. See TORQUE SPECIFICATIONS . Ensure alignment is correct as engine and transaxle-to-subframe mounts are installed.
  4. Install NEW pinch bolts and nuts for lower ball joints. Fill transaxle with appropriate fluid. See appropriate AUTOMATIC TRANSMISSION article. Check and adjust axle shaft positioning. See appropriate FWD AXLE SHAFTS article in DRIVE AXLES.
scientia non olet · About LEMON Manuals