LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Diagnosis - Ax4N >> Diagnosis & Testing >> Reading Diagnostic Trouble Codes >> Continuous Memory Codes (Intermittent Faults)

Continuous Memory Codes (Intermittent Faults)

CAUTION: Continuous memory codes should be recorded when retrieved. These DTCs may be used to identify intermittent faults that exist after all KOEO and KOER DTCs have been repaired. Some continuous memory code faults may not be valid after KOEO and KOER DTCs are serviced.

These DTCs result from information stored by PCM during continuous self-test monitoring. Use these DTCs for diagnosis only when KOEO SELF-TEST and KOER SELF-TEST result in SYSTEM PASS and all steps in QUICK TEST are successfully completed. These DTCs indicate faults previously recorded. Fault may or may not be currently present. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table. After noting and/or repairing concern, clear codes from memory. See CLEARING DIAGNOSTIC TROUBLE CODES  . Intermittent faults may be caused by a sensor, connector or wiring-related concern.

DIAGNOSTIC TROUBLE CODE IDENTIFICATION

DTC (1) Code Definition (2) System Test
P0705 Digital TR Sensor Failure C 
P0708 Digital TR Sensor Circuit TR3A Open C 
P0712 TFT Sensor Indicates 340°F (171°C), Sensor Circuit Grounded B 
P0713 TFT Sensor Indicates -45°F (-43°C), Sensor Circuit Open B 
P0715 Insufficient Input From TSS Sensor F 
P0717 Insufficient Input From TSS Sensor F 
P0718 Intermittent TSS Sensor Signal F 
P0720 Insufficient Input From OSS Sensor G 
P0721 Noisy OSS Sensor Signal G 
P0722 Intermittent OSS Sensor Signal G 
P0731 1st Gear Error, SSA, SSB Or Internal Components (3) A 
P0732 2nd Gear Error, SSA, SSB Or Internal Components (3) A 
P0733 3rd Gear Error, SSA, SSC Or Internal Components (3) A 
P0734 4th Gear Error, SSA, SSC Or Internal Components (3) A 
P0741 TCC Failure G 
P0743 TCC Solenoid Circuit Failure (4) C 
P0750 SSA Solenoid Circuit Failure (4) A 
P0751 SSA Solenoid Functional Failure (3) A 
P0755 SSB Solenoid Circuit Failure (4) A 
P0756 SSB Solenoid Functional Failure (3) A 
P0760 SSC Solenoid Circuit Failure (4) A 
P0761 SSC Solenoid Functional Failure (3) A 
P1000 Incomplete OBD-II Testing N/A
P1111 System Pass Code N/A
P1700 Transaxle Mechanical Failure (5)
P1702 Intermittent DTC P0705 & P0708 Conditions C 
P1704 Digital TR Sensor Circuit D 
P1705 Digital TR Sensor Not In Park During OBD Testing Or Digital TR Sensor Circuit Shorted D 
P1711 Transaxle Not At Operating Temperature 25-240°F (-4-116°C) During OBD Testing B 
P1713 PCM Detected No TFT Sensor Change At Low-Range (6) B 
P1714 SSA Failure (7) H 
P1715 SSB Failure (7) H 
P1716 SSC Failure (7) H 
P1718 PCM Detected No TFT Sensor Change At High-Range (6) B 
P1740 TCC Solenoid Failure (7) C 
P1741 TCC Continuous Slip (3) C 
P1742 TCC Solenoid Failed On (3) C 
P1743 TCC Solenoid Failed On (3) C 
P1744 TCC Excessive Slip C 
P1746 Open PCM Output Driver (4) E 
P1747 EPC Solenoid Circuit Failure (4) E 
P1751 SSA Solenoid Functional Failure (3) A 
P1756 SSB Solenoid Functional Failure (3) A 
P1760 EPC Solenoid Circuit Failure (4) E 
P1761 SSC Solenoid Functional Failure (3) A 
P1767 TCC Solenoid Circuit Failure (4) C 
P1783 Transmission Temperature Exceeded 300°F (149°C) B 
P1901 PCM Detected Intermittent TSS Signal F 
(1) Only engine performance-related DTCs that may affect transmission operation are listed. For complete list of engine performance-related DTCs, see appropriate SELF-DIAGNOSTICS - EEC-V article in ENGINE PERFORMANCE.
(2) For test procedures, see SYSTEM TESTS  .
(3) DTC may be generated by non-electrical transaxle hardware system.
(4) Output circuit check, generated by electrical symptom only.
(5) Low one-way clutch failure. Also check fluid level.
(6) DTC may cause TCIL to flash.
(7) Mechanical or hydraulic failure of solenoid.
scientia non olet · About LEMON Manuals