Retrieving Codes

Fault codes are retrieved from EEC-V system through 16-pin Data Link Connector (DLC). DLC is located below instrument panel, to right of steering column. Self-diagnostic test procedures are written for use with New Generation Star (NGS) tester. If an aftermarket scan tool is used, ensure tool is OBD-II certified and refer to scan tool manufacturer's operating procedures.

During QUICK TEST  , 3 types of DTCs can be retrieved: KOEO, KOER and continuous memory codes. See QUICK TEST  under DIAGNOSIS & TESTING for code retrieval procedures. Codes may be cleared from PCM memory after they have been noted and concerns are repaired. See CLEARING DIAGNOSTIC TROUBLE CODES  under DIAGNOSIS & TESTING.