Disabling System (Impala & Monte Carlo)
- Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS . Turn front wheels to straight-ahead position. Turn ignition switch to OFF position and remove key from ignition switch.
- Remove SDM fuse from fuse block at far left end of instrument panel. Fuse block is under access cover. Wait 10 minutes.
- Remove access hole cover from far right end of instrument panel. Unclip front air bag Yellow 4-pin connector from metal rail. Remove Connector Position Assurance (CPA) clip and disconnect Yellow 4-pin air bag connector.
- Move driver's seat as far back as possible. Remove CPA clip and disconnect the driver side air bag 2-pin Yellow SIR connector, if equipped. Connector is located under driver's seat.