Removal and Installation

WARNING: This page is about a different variant/trim than selected.

Drain the engine cooling system. .
Remove the air cleaner outlet tube.
Remove the coolant pump belt tensioner, if equipped. For additional information, refer to SPECIFICATIONS & DRIVE BELT ROUTING .
Disconnect the three hoses.

Fig 1: Disconnecting Three Hoses
Courtesy of FORD MOTOR CO.
Remove the bolts and the coolant pump assembly.

Fig 2: Removing Bolts & Coolant Pump Assembly
Courtesy of FORD MOTOR CO.
Separate the coolant pump from the coolant pump housing.

Fig 3: Separating Coolant Pump From Coolant Pump Housing
Courtesy of FORD MOTOR CO.

NOTE: Clean and inspect the sealing surfaces.