LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine - 3.0L V6 - VIN S & 1) >> Removal & Installation >> Fuel Pressure Release >> Fuel Fittings

Fuel Fittings

WARNING: This page is about a different variant/trim than selected.
  1. To disconnect fuel lines, remove retaining clip from fuel line coupling. Use Spring Lock Coupling Remover (D87L-9280-A) for 3/8" line and (D87L-9280-B) for 1/2" line. Install spring lock coupling remover on fuel line coupling so it enters cage opening. See Figure.
  2. Push spring lock coupling remover into cage opening to release female fitting from garter spring. Pull couplings apart. Remove spring lock coupling remover.
  3. When installing fuel lines, install NEW "O" rings on fuel lines. Use only specified fuel-resistant "O" rings (Brown). Before installing, lightly coat "O" rings with clean engine oil. Clean fittings, and replace garter spring (if necessary).
  4. Install female fitting to male fitting and push until garter spring snaps over flared end of female fitting. Ensure lines are locked together and garter spring is over flared end of female fitting. Install retaining clip. Ensure horseshoe portion of clip is over coupling. DO NOT install retaining clip over rubber fuel line.
scientia non olet · About LEMON Manuals