LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine - 3.0L V6 - VIN S & 1) >> Removal & Installation >> Crankshaft Rear Oil Seal >> Removal

Crankshaft Rear Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.

Remove transaxle. See REMOVAL & INSTALLATION - A/T article in TRANSMISSION SERVICING. Mark position of flywheel to crankshaft flange. Remove flywheel. Using Seal Remover (T95P-6701-EH), and slide hammer, remove seal from block.

scientia non olet · About LEMON Manuals