Crankshaft Rear Oil Seal: Installation

WARNING: This page is about a different variant/trim than selected.

Lubricate crankshaft flange and oil seal bore with Engine Assembly Lubricant (D9AZ-19579-D). Using Rear Main Seal Replacer (T82L-6701-A) and Rear Crank Seal Replacer Adapters (T91P-6701-A), install rear oil seal. Ensure seal is seated within.000-.020" (.00-.51 mm) of flush with edge of cylinder block. To complete installation, reverse removal procedure. Tighten bolts/nuts to specification. See TORQUE SPECIFICATION .