LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine - 3.0L V6 - VIN S & 1) >> Removal & Installation >> Crankshaft Front Oil Seal >> Installation

Crankshaft Front Oil Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply Engine Assembly Lubricant to oil seal. Using Front Crankshaft Seal Replacer (T88T-6701-A) and Crankshaft Damper Replacer (T74P-6316-B), install oil seal. Apply Sealant (F4AZ-19562-B) to crankshaft damper keyway before installing damper.
    2. NOTE: The pulley has a reverse thread.
  2. Use crankshaft damper replacer and retaining bolt washer to install crankshaft damper. Tighten crankshaft damper retaining bolt to specification. To complete installation, reverse removal procedure. Tighten remaining bolts and nuts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals