LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 997 (Anti-Lock Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Speed Sensor - Front, Four Wheel Drive (4WD) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front disc brake rotor shield. For additional information, refer to FRONT DISC BRAKE article.
  2. Disconnect the front wheel speed sensor electrical connector.
  3. Remove the 4 wheel speed sensor harness retainers.
    CAUTION: Make sure the ABS harness is properly routed to prevent the disc from cutting the ABS harness.
  4. Remove the screw and the front wheel speed sensor.
    • To install, tighten to 18 Nm (13 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals