Vehicles with occupant classification sensor (OCS) system
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- When a vehicle has been involved in a collision and the OCS module has DTC B1231 stored in memory, the repair of the OCS system is to include the following procedures for the specified system:
- For rail type OCS system, inspect the passenger side floorpan for damage and repair as necessary. Install new OCS rails.
- For weight sensor bolt type OCS system, inspect the passenger side floorpan for damage and repair as necessary. Install a new seat track with OCS weight sensor bolts.
- For bladder type OCS system, inspect for damage and repair as necessary. If installation of an OCS component is required, an OCS service kit must be installed.
NOTE: Most bladder type OCS modules do not store a DTC B1231 in memory after deployment. The DTC B1231 is stored only by the RCM.
NOTE:
After installation of new occupant classification sensor (OCS) components carry out the OCS System Reset procedure as instructed in the workshop manual. Refer to the appropriate workshop manual for OCS system removal and installation procedure.