LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 986 (Instrument Panel And Console F250-F550)) >> Removal And Installation >> Console - Overhead >> Removal And Installation >> Crew Cab vehicles

Crew Cab vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear B-pillar assist handles.
    • Remove the 4 covers (2 on each handle).
    • Remove the 4 screws (2 on each handle).
    • Remove the 2 B-pillar assist handles.
    Fig 1: Identifying Rear B-Pillar Assist Handles Covers And Screws
    GF0005272Courtesy of FORD MOTOR CO.
    2. CAUTION: If the safety belt retractor is to be reused, do not allow the safety belt to be retracted all the way into the retractor. Doing so may cause the retractor to lock and not release the safety belt.
    NOTE: Inspect the shoulder safety belt guide and cover for damage. If the shoulder safety belt guide or cover is damaged or cover does not remain closed, install a new shoulder safety belt guide.
    Fig 2: Identifying Shoulder Safety Belt Guide
    GF0004835Courtesy of FORD MOTOR CO.
  2. Remove the LH and RH shoulder safety belt guides.
    • Position the shoulder safety belt guide cover up.
    • Remove the shoulder safety belt guide nut.
      • To install, tighten to 40 N.m (30 lb-ft).
    • Remove the shoulder safety belt guide.
  3. Position the B-pillar trim panels aside.
    Fig 3: Positioning B-Pillar Trim Panels Aside
    GF0004872Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals