Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the side shield. For additional information, refer to Seat Backrest - Front, Bucket and 40 Percent in this article.
Remove the seat track. For additional information refer to Seat Track - Bucket and 40 Percent in this article.
Disconnect the electrical connectors and remove the wire harness.

Fig 1: Locating Wire Harness
Courtesy of FORD MOTOR CO.
Remove the 2 lumbar actuator screws.

Fig 2: Locating Lumbar Actuator Screws
Courtesy of FORD MOTOR CO.
Unclip the lumbar control cable from actuator.

Fig 3: Locating Lumbar Control Cable
Courtesy of FORD MOTOR CO.
Remove the 2 bolts and remove the front seat adjuster.
- To install, tighten to 50 Nm (37 lb-ft).
Fig 4: Locating Front Seat Adjuster Bolts
Courtesy of FORD MOTOR CO.

CAUTION: Do not damage the plastic pivot bushing when removing the seat backrest.

Fig 5: Separating Seat Cushion From Seat Backrest

Courtesy of FORD MOTOR CO.

Pull the front seat backrest away from the seat hinge and feed the lumbar cable and heating element wire through the seat cushion opening. Separate the seat cushion from the seat backrest.
To install, reverse the removal procedure.