Seat Control Switch - With Seat Integrated Restraints (SIR): Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Position the seat control switch and install 2 screws.

Fig 1: Locating Screws On Seat Control Switch
Courtesy of FORD MOTOR CO.
Connect the seat control switch electrical connector.

Fig 2: Locating Seat Control Switch Electrical Connector
Courtesy of FORD MOTOR CO.

NOTE: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.

Fig 3: Locating Seat Backrest Pivot Bolt Shaft And Cover

Courtesy of FORD MOTOR CO.

Position the side trim cover. Install the 3 trim cover screws.
- The seat backrest pivot bolt shaft must be inserted into the cover standoff.
Push the rearward lower corner of the side shield to engage the metal retaining clip.
Position the lumbar adjuster control. Install the 2 mounting screws. Install the adjuster knob.

Fig 4: Identifying Seat Adjuster Control Knobs, Covers And Seat Side Trim Panel Screws
Courtesy of FORD MOTOR CO.
Position the seat back recliner lever cover. Install the screw.

Fig 5: Locating Seat Back Recliner Lever Cover
Courtesy of FORD MOTOR CO.
Install the front seat. For additional information, refer to Seat - Front, With Seat Integrated Restraints (SIR) in this article.