LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Backrest - Rear, 60/40, CrewCab >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 60/40 percent rear seat. For additional information, refer to Seat - Rear, 60/40, CrewCab  in this article.
  2. Remove the 2 bolts from the back side of the center support.
    • To install, tighten to 50 Nm (37 lb-ft).
  3. Separate the 40 percent seat and the 60 percent seat from the center support.
  4. Remove the screw and the side latch shield.
  5. Remove the screw and the cushion release handle.
  6. Pry the side shield to release the 3 clips and remove the side shield.
  7. Remove the 2 bolts and remove the backrest assembly.
    • To install, tighten to 50 Nm (37 lb-ft).
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals