Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: New retaining bolts must be installed, do not reuse the bolts that were removed. Studs and nuts can be reused.

Remove the seat mounting retainer covers.
From the bottom of the seat backrest, push the seat backrest upward, then pull the bottom outward and remove from vehicle.

Fig 1: Pushing And Pulling Seat Backrest
Courtesy of FORD MOTOR CO.
Position the seat cushions back, then remove and discard the bolts.
- To install, tighten to 55 Nm (41 lb-ft).
Fig 2: Locating Seat Cushions Back Bolts
Courtesy of FORD MOTOR CO.
Remove and discard the bolt.
- To install, tighten to 55 Nm (41 lb-ft).
Fig 3: Locating Bolt
Courtesy of FORD MOTOR CO.
Remove and discard the bolt and remove the nut.
- To install, tighten to 55 Nm (41 lb-ft).
Fig 4: Locating Bolt And Nut
Courtesy of FORD MOTOR CO.
Remove the nut.
- To install, tighten to 55 Nm (41 lb-ft).
Fig 5: Locating Nut
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Make sure the safety belt is not twisted prior to installation.
- Make sure the safety belts and buckles are accessible to the occupants after installation.