LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat - Front, Bucket and 40 Percent >> Removal And Installation >> All seats

All seats

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Passenger front inboard retainer cover shown, driver cover similar.
    Fig 1: Removing Front Inboard Retainer Cover
    GF0004964Courtesy of FORD MOTOR CO.
  1. Remove the front inboard retainer cover.
    2. NOTE: Passenger rear inboard retainer cover shown, driver similar.
  2. Remove the rear inboard retainer cover.
  3. Move the seat to its forward most position.
    Fig 2: Removing Rear Inboard Retainer Cover
    GF0004968Courtesy of FORD MOTOR CO.


    CAUTION: When installing the seat, tighten the front mounting bolts, then the rear mounting bolt or nut(s).
  1. To install, reverse the removal procedure.
    • Make sure the safety belt and buckle are accessible to the occupant after installation.
    • Make sure the safety belt webbing is not twisted prior to installation.
    • Adjust the seat to the full forward and rearward positions a few times to make sure of safety belt and buckle accessibility.
scientia non olet · About LEMON Manuals