LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat - Front, 20 Percent >> Installation

Seat - Front, 20 Percent: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat.
  2. Position the safety belt anchor. Install the 20 percent seat riser-to-floor LH rear nut.
    • Make sure the safety belt is not twisted prior to installation.
      • Tighten to 55 Nm (41 lb-ft).
  3. Install the new 20 percent seat riser-to-floor RH rear bolt.
    • Tighten to 55 Nm (41 lb-ft).
  4. Install the front seats. For additional information, refer to Seat - Front, With Seat Integrated Restraints (SIR)  or Seat - Front, Bucket and 40 Percent  in this article.
  5. Make sure the safety belt and buckles are accessible to the occupants after installation.
scientia non olet · About LEMON Manuals