Disassembly And Assembly

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear bench seat backrest. For additional information, refer to Seat Backrest - Rear, Bench, CrewCab in this article.
Remove the 2 armrest bracket bolts, if so equipped, to remove the armrest from the back assembly.
- To install, tighten to 12 Nm (9 lb-ft).
Fig 1: Locating Armrest Bracket Bolts
Courtesy of FORD MOTOR CO.
Remove the rubber insert.

Fig 2: Locating Rubber Insert
Courtesy of FORD MOTOR CO.
Remove the screws and cupholder.

Fig 3: Locating Screws And Cupholder
Courtesy of FORD MOTOR CO.
Unzip the armrest cover and remove from the armrest.

Fig 4: Unzipping Armrest Cover
Courtesy of FORD MOTOR CO.
Unfasten the seat back cover J-clips and remove the cover.

Fig 5: Removing Cover
Courtesy of FORD MOTOR CO.
Remove the seat back cushion foam pad from the seat back frame.

Fig 6: Removing Seat Back Cushion Foam Pad
Courtesy of FORD MOTOR CO.
Remove the 4 armrest bolts and remove armrest brackets.
- To install, tighten to 50 Nm (37 lb-ft).
Fig 7: Locating Four Armrest Bolts
Courtesy of FORD MOTOR CO.
To assemble, reverse the disassembly procedure.