Pinpoint Test AE: The Daytime Running Lamps Are On With The Parking Brake Set
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- AE1 CHECK THE DRL PARKING BRAKE RELAY CIRCUIT
- Apply the parking brake.
- Key in ON position.
- Disconnect: DRL Relay 1 C1171
- Do the DRL continue to illuminate?
- AE2 CHECK CIRCUIT 162 (LG/RD) FOR AN OPEN
- Key in OFF position.
- Measure the resistance between the DRL 1 relay C1171-2, circuit 162 (LG/RD), harness side and ground.
- Is the resistance less than 5 ohms?
- YES : Go to AE3.
- NO : REPAIR the circuit. TEST the system for normal operation.
- AE3 CHECK CIRCUIT 295 (LB/PK) FOR AN OPEN
- Key in ON position.
- Measure the resistance between the DRL 1 relay C1171-1, circuit 295 (LB/PK), harness side and ground.
- Is the voltage greater than 10 volts?
- YES : INSTALL a new DRL 1 relay. TEST the system for normal operation.
- NO : REPAIR the circuit. TEST the system for normal operation.
- AE4 CHECK CIRCUIT 175 (BK/YE) FOR A SHORT TO POWER
- Disconnect: DRL Relay 2 C1172
- Do the DRL continue to illuminate?
- YES : Go to AE5.
- NO : REPAIR the circuit. TEST the system for normal operation.
- AE5 CHECK CIRCUIT 1032 (WH/BK) FOR A SHORT TO POWER
- Disconnect: DRL Relay 3 C1000
- Carry out the relay component test for the DRL relay 3. Refer to COMPONENT TESTING article.
- Is the DRL relay 3 OK?
- YES : REPAIR the circuit. TEST the system for normal operation.
- NO : INSTALL a new DRL relay 3. TEST the system for normal operation.