LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 975 (Fuel Charging And Controls - 6.8L (3V) - F250-F550) >> Removal And Installation >> Throttle Body - Spacer >> Removal

Throttle Body - Spacer: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and can be ignited. Failure to follow these instructions may result in personal injury.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Remove the throttle body (TB). For additional information, refer to Throttle Body  in this article.
  3. Disconnect the main vacuum harness from the TB spacer.
  4. Disconnect the positive crankcase ventilation (PCV) tube quick connect coupling from the TB spacer. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
  5. Disconnect the evaporative emissions (EVAP) canister purge valve vacuum tube quick connect coupling from the TB spacer. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
  6. Disconnect the brake booster vacuum hose.
  7. Remove the 2 PCV heated element screws.
  8. Remove the PCV heated element.
  9. Remove the 2 upper TB spacer bolts.
  10. Remove the 4 lower TB spacer bolts, the TB and discard the TB spacer gasket.
scientia non olet · About LEMON Manuals