LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 973 (Brake System - General Information -- F250-F550 Super Duty) >> General Procedures >> Component Bleeding >> Anti-Lock Brake System Hydraulic Control Unit (HCU)

Anti-Lock Brake System Hydraulic Control Unit (HCU)

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure only needs to be carried out if a new anti-lock brake hydraulic control unit (HCU) has been installed or if air is suspected in the HCU.
  1. Carry out the brake system bleeding procedure. For additional information, refer to Brake System Bleeding  in this article.
  2. Connect the scan tool to the vehicle data link connector (DLC) under the dash and follow the scan tool instructions.
  3. Repeat the brake system bleeding procedure. For additional information, refer to Brake System Bleeding  in this article.
scientia non olet · About LEMON Manuals