LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 963 (Clutch System -- F250-F550 Super Duty) >> Removal And Installation >> Flywheel >> Removal

Removal And Installation: Flywheel: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the vehicle for flywheel removal.
    1. Remove the transmission. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION - ZF 6-SPEED article.
    2. Remove the clutch pressure plate and disc. For additional information, refer to Clutch Disc and Pressure Plate  in this article.
  2. Remove the flywheel.
    1. Remove the bolts. Install the guide studs.
    2. Remove the bolts.
    3. Remove the reinforcing ring (6.0L) and the flywheel and ring gear assembly.
    4. Remove the guide studs.
    Fig 1: Identifying Bolts And Guide Studs - 6.0L
    GF0007152Courtesy of FORD MOTOR CO.
    Fig 2: Identifying Bolts And Guide Studs - 5.4L And 6.8L
    GF0007153Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals