RWD vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the wire harness from the rear crossmember.

Fig 1: Locating Wire Harness At Rear Of Crossmember

Courtesy of FORD MOTOR CO.

Remove the rear transmission mount nuts.

Fig 2: Identifying Transmission Support Insulator Nuts

Courtesy of FORD MOTOR CO.

Remove the nut and disconnect the fuel line bracket.

Fig 1: Identifying Fuel Line Bracket Bolts

Courtesy of FORD MOTOR CO.

Remove the LH crossmember bolts and nuts.
- Loosen, but do not remove, the bolt and nut indicated.

Fig 2: Locating LH Crossmember Bolts

Courtesy of FORD MOTOR CO.

Remove the RH crossmember bracket bolts and nuts.
- Remove the bracket bolts and nuts.
- Remove the bracket.

Fig 3: Locating RH Crossmember Bracket Bolts

Courtesy of FORD MOTOR CO.

Remove the RH crossmember bolts and nuts.

Fig 4: Identifying RH Crossmember Bolts And Nuts

Courtesy of FORD MOTOR CO.

Remove the LH crossmember bolt, nut and the crossmember.
- Remove the bolt and nut.
- Remove the crossmember.

Fig 5: Locating LH Crossmember Bolt

Courtesy of FORD MOTOR CO.

Remove the rear transmission mount from the extension housing.

Fig 6: Locating Rear Transmission Mount Bolts At Extension Housing

Courtesy of FORD MOTOR CO.

If equipped with dual generators, rotate the tensioner and remove the outer accessory drive belt from the crankshaft pulley.

Fig 7: Removing Outer Accessory Drive Belt From Crankshaft Pulley

Courtesy of FORD MOTOR CO.