LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 960 (Automatic Transmission - 5R110W -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Internal Harness Service >> Installation

Internal Harness Service: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Push the bulkhead connector through the transmission solenoid body, twist it to lock it in place.
  2. Connect the internal wiring harness.
    • Install the 2 screws.
    • Connect the TFT sensor electrical connector.
    • Connect the solenoid electrical connectors.
    3. Fig 1: Identifying Solenoid Electrical Connectors
    GF0006824Courtesy of FORD MOTOR CO.
    NOTE: The O-ring seal must be installed in the top slot.
  3. Install a new solenoid body bulkhead connector O-ring seal and lubricate it with clean automatic transmission fluid.
    4. Fig 2: Identifying Bulkhead Connector O-Ring
    G03889120Courtesy of FORD MOTOR CO.
  4. Install the solenoid body assembly. For additional information, refer to Solenoid Body Assembly  in this article.
scientia non olet · About LEMON Manuals