LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 960 (Automatic Transmission - 5R110W -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Extension Housing Gasket - Rear Wheel Drive (RWD) >> Removal >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driveshaft. For additional information, refer to DRIVESHAFT article.


  1. Remove the rear transmission insulator nuts.
    2. Fig 1: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
  2. Install a suitable transmission jack.
  3. Remove the rear transmission insulator bolts.
    4. Fig 2: Identifying Transmission Support Insulator Bolts
    G03889100Courtesy of FORD MOTOR CO.
  4. Raise the transmission upward, off the rear transmission insulator and remove the rear transmission insulator.
    5. Fig 3: Locating Rear Transmission Mount
    GF0006821Courtesy of FORD MOTOR CO.
  5. Disconnect the output shaft speed (OSS) sensor electrical connector.
    6. Fig 4: Identifying Output Shaft Speed (OSS) Sensor Electrical Connector
    G03889074Courtesy of FORD MOTOR CO.


  1. Remove and discard the extension housing gasket.
    2. Fig 1: Locating Extension Housing Gasket
    G03889106Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals